• f/tKCimage1

    Features

    • Run dry capability 24 hrs. or more for KC5.5 through KC11, 10 minutes for KC22/32. Under a minute for KC3, 4 , 5.†
    • Specific gravities to 1.8
    • Accepts standard NEMA 56C, 145TC, 184TC, 213TC or IEC metric motors (excludes KC3, 4 & 5)
    • Modular design for component interchangeability
    • Unmatched coupling strength
    • Chemical resistant polypropylene or PVDF materials
    • No environmental contamination
    • Discharge port o-ring available on selected models
    • Temperatures: PP – 180ºF (82ºC) PVDF – 220ºF (104ºC

  • f/tDBimageFrontal

    Features

    • Close-coupled design
    • Polypropylene or PVDF construction
    • Replaceable shaft + ISO 1940 G2.5 balancing
    • Mounts to Nema and IEC motor frames
    • Mounts to motor without disassembly
    • Back pullout design
    • Five-year warranty
    • CE certified/ATEX available

    Capabilities

    • High operating efficiency— up to 70%
    • High working pressure— up to 90 psi
    • High specific gravity handling—over 1.8
    • Maximum viscosity: 150 cP
    • Maximum Temperature: Polypropylene—180º F (82º C); PVDF—220º F (104º C)

  • f/tSPsinglepumpImage

    Features

    • Magnetic drive
    • Five-year warranty
    • Excellent for pumping from above or below ground storage
    • Provides up to 25 feet (7.6 m) of lift
    • SP11/15 prime 18 feet (5.5 m) in 90 seconds**
    • Retains fluid for re-priming when shut off without a check valve
    • Up to 90 psi working pressure (6.2 bar)
    • Runs without damage in absence of continuous flow
    • Handles over 1.8 SG
    • Back pull-out design for easy service

    **with maximum diameter impeller

    Construction

    • Corrosion resistant polypropylene (180°F/82°C) or PVDF (220F/104°C)
    • Rare earth neodymium magnets
    • Molded-in “gooseneck” suction passage eliminates need for internal check valves
    • Easy set outer drive ensures optimum magnet alignment and easy motor installation
    • Viton® or EPDM o-rings standard. Other options available
    • Carbon, ceramic, PTFE or silicon carbide bushings
    • Mounts to NEMA or IEC motor frames • NPT or BSP threads, flange or union connections
    • Special design inner volute enables fast priming

    Applications

    • Bulk unload or transfer from rail cars, tanker trucks, sumps, pits, day storage or underground storage tanks to process or storage locations
    • Over-the-wall applications
    • Piping systems that have trapped or entrained air
    • When run-dry protection is needed

    Typical Chemicals

    • Sodium hydroxide, sodium hypochlorite
    • Sulfuric acid, hydrochloric acid, nitric acid
    • Corrosive blends, waste water

    Caution: The SP Series is not recommended for pumping flammables.